Important Safeguards; Safety Switch; Filling Oil - Valentine TF5/55 Manual De Instrucciones

Important safeguards:

Before connecting the power and/or filling with oil, set the switch [1] to
"0". Never heat up without oil!

Safety switch:

Once the heating element is raised more than 5 mm, the safety switch
is activated and interrupts the current.
make sure that the heating element housing is resting on the edge of
the tank and that the two rods [14] fixed to the chassis go into the housing.

Filling oil:

Pour oil into the tank as far as the MAX level mark [8]
It is not advisable to use animal and vegetable fats that solidify. If the use of the fat
cannot be avoided, it must be melted in a pan. Never melt hard blocks of fat on the
heating element.
Always top up with oil after use. When the oil level is too low the efficiency drops con-
siderably and the oil is overheating.
22
Commissioning

If there is a protective plastic sheet this needs to be re-
moved.

The voltage, current and power must correspond to the
information specified on the rating plate [17] on the back of
Heating element box [21] of the appliance.

In all cases, the fryer must be connected to the safety earth
with the connection cable [16].

Clean the tank with warm, soapy water then
dry well.
Check that the drain valve is fully closed be-
fore filling.