Skoda 5E0 054 630 Manual De Instrucciones página 15

car. Run the parking sensor wires through the hole and carefully adjust the bushing (D)
- is included in the parking sensor wire harness.
- 9, 10 -
Fastening the parking sensor wires - bumper stiffener
- Place fasteners (G) on the bottom of the bumper stiffener, approximately to the places
shown in the figure.
- Proceed as follows to fix the sensor wires in the fasteners:
- first fastener - short 1 wire,
- second fastener - 2 wires (short and the shortest),
- third fastener - 2 wires (long and the longest),
- fourth fastener - 1 wire (the longest; the long remains loose).
Advice. Fasten all wires in such a way that the end with the connector
remained loose, in a length of about 30 cm.
- 11 -
Fastening the parking sensor wires - towing coupling
- Using two tightening tapes (J), fasten the sensor wires on the towing coupling support in
the same order as when using the fasteners on the bumper stiffener.
Advice. Fasten all wires in such a way that the end with the connector
remained loose, in a length of about 30 cm.
Important. At the electrical installation socket, fix the wires
additionally with a tightening tape to avoid collision of the wires with
the hinged socket holder.
- 12, 13 -
- Snap the wire terminal boards in the parking sensor wires. Refit the rear bumper.
- In the area under the bumper at the vehicle exhaust, fasten the sensor wires together with
a tightening type (H) so that they are at a sufficient distance from the exhaust piping, and
damaging (blowing out) them is avoided.
Advice. In vehicles with double-exhaust system fasten the sensor
wires together with a tightening type in the area under the bumper at
both exhausts!
- 14, 15, 16 - ŠKODA Octavia
Fastening the loudspeaker
- Attach the loudspeaker (C) with a Velcro fastener on the C-pillar bodywork, approximately to
the place as shown in the figure, so that the wire aims downwards the trunk.
Fastening the loudspeaker wire
- First provide the circumference of the edge of the stalk for fixing the safety belt reel with a
foam adhesive tape (L).
EN
15