Lofting; Add/Subtract Measurement - Tripp-Lite T030-50M El Manual Del Propietario

Operation

Lofting

1 Turn on the device. Press and hold
2 Designate the a value (initial distance from the target) and b value (spacing
interval distances) by using
digit values).
3 Once values are set, place the meter on a flat surface and near the wall.
Press
wall until the value on the screen reads 0 (initial point).
4 Continue to slowly move the meter further away from the wall and mark
every space where the value on the screen reads 0.

Add/Subtract Measurement

Single distance measurement is calculated by adding/subtracting to get an
accumulated measurement.
1 Quickly press
activate the laser. Once the laser is activated, press
appear on the main screen. You can switch between adding ( )
or subtracting ( ) by pressing
each measurement point.
• In the Distance mode, the accumulative value or distance between the
measurements taken will display on the main screen.
• In the Area/Volume mode, after taking measurements, press
calculate. The results will display on the main screen.
17-07-267-93374D.indb 10
to activate the laser. Slowly move the meter away from the
to turn on the device, then press
10
for 2 seconds.
(to move digits) and
repeatedly. Pressing
(to adjust
again to
. The icon will
will set
to
9/6/2017 8:36:59 AM