Operation; On/Off Function; Taking Measurements; Single Measurement - Tripp-Lite T030-50M El Manual Del Propietario

Operation

On/Off Function

1 To turn on the device, press
laser.
2 To turn off the device, press and hold
3 When the device is on but not in use, the backlight will shut off within 15
seconds. After 30 seconds of no use, the laser will shut off. The device will
automatically shut off after 3 minutes of inactivity.

Taking Measurements

Single Measurement

Turn on the device and activate the laser. Once the laser is activated, press
display on the screen and automatically be stored in the system.

Continuous Measurement

Turn on the device and activate the laser. Once the laser is activated, press and
hold
The main display will indicate the measured results, and the auxiliary screen
will show the maximum and minimum distances measured.

Area Measurement

Turn on the device and activate the laser. Once the laser is activated, quickly
press
edge will flash. When this happens, do the following:
1 Press
2 Press
The device will automatically calculate the area and its measurement will
display on the screen. Press
prepare for the next measurement.
17-07-267-93374D.indb 7
to get a single distance measurement. Measurement results will
for 2 seconds to start the continuous measurement function.
for the icon to display on the LCD screen. The icon's bottom
to measure the first edge (length).
to measure the second edge (width).
. Press again to activate the
for 3 seconds.
to remove the previous result and
7
9/6/2017 8:36:59 AM