Volume Measurement; Pythagorean (Indirect) Measurement - Tripp-Lite T030-50M El Manual Del Propietario

Operation

Volume Measurement

Turn on the device and activate the laser. Once the laser is activated, press
will flash. When this happens, do the following:
1 Press
2 Press
3 Press
The device will automatically calculate the volume and display the
measurement on the screen. Press
prepare for the next measurement.

Pythagorean (Indirect) Measurement

Notes:
• There are three measuring modes to get unilateral distance measurements by way
of the Pythagorean theorem. This is a convenient way for users to indirectly measure
within complex environments. Pressing
instructions for details.
• The length of the right side of the triangle must be shorter than the hypotenuse side in
order for the device to calculate the measurement. If this is incorrect, the device will
display an error signal.
• To ensure accuracy, the measurement must be measured from the same starting point
with a measuring order of hypotenuse and then right side.
1 Turn on the device and activate the laser. Once the laser is activated, press
triangle's hypotenuse will flash. Press
of the (a) dotted line of triangle. Repeat this step to measure the second
dotted line of the triangle (b). The length of (x) of the solid line is calculated
automatically by the meter.
17-07-267-93374D.indb 8
twice for the screen to display the
to measure the first edge (length).
to measure the second edge (width).
to measure the third edge (height).
three times for the screen to display the
icon. One of the cube icon's edges
to remove the previous result and
will activate this mode. See the below
icon. In the icon, the
to first measure the length
8
9/6/2017 8:36:59 AM