Publicidad
STEP 1
To assemble the slides, attach the
cross bar into the feet
(See Figure 1A).
Attach the left and right slides
respectively to the top of the
feet. You will feel a "snap"when
connected completely
(See Figure 1B).
Once slides are assembled, set
them to the side.
STEP 2
Remove the slide triggers from their
wrapping.
Turn your waste container chassis
over and locate the pre-drilled holes
on the front lip of the box
(See Figure 2A).
Using (4) #6 x 1/2" deep thread pan
head screws, attach the left and
right sided triggers (See Figure 2B)
and set the waste container chassis
to the side.
NOTE:
Release triggers are side sensitive
and are marked with an "L" & "R"
for Left and Right.
#2
STEP 3
Place template into cabinet and
position thefront edge to where
the back of your door will be when
closed (See Figure 3).
Inset door = set back the thickness
of your door
Overlay door = place at the front
edge of cabinet
Using an awl or pencil, mark
through the bold dotted screw
locations onto your cabinet floor.
Remove template when done.
Using your 3/32" drill bit, pre-drill
in all 8 locations making sure to
NOT drill through the cabinet floor
completely.
Lay your assembled slide set over
the top of the marked holes. Using
(8) #6 X 1" deep thread Phillips
head screws, attach the slides to
the cabinet floor through the gray
slide feet holes.
Place your waste container chassis
with attached triggers on top of the
slides and push back until you hear
the "click" sound.
3
32
2
FIG. 2A
Pre-drilled holes
FIG. 3
#2
Customer Service: 800-626-1126 | rev-a-shelf.com
FIG. 1A
Note: The ideal distance
between bracket
screws should be
21-5/8", allowing
for maximum
adjustability.
FIG. 1B
FIG. 2B
Slide triggers
23.00
23"
[584,3]
21.63
21-5/8"
[549,3]
20.25
21-1/4"
[514,4]
This drawing is the property of Rev-A-Shelf (RAS) and is disclosed
in confidence to the extent its subject matter is original to RAS. Any
vendor receiving this drawing from RAS shall hold and use this drawing
for the sole benefit of RAS and shall not disclose it to, or use or
reproduce it for any third party, or perform any act adverse to the interest
of RAS with respect to this drawing without the express written permission
of RAS. Vendors shall not revise any physical, dimensional or
performance characteristic unless authorized by Rev-A-Shelf Engineering.
5.00
5"
[127]
9.82
9-13/16"
[249,3]
REV.
DATE
BY
Publicidad
