Publicidad
STEP 4
Re-install door mount brackets.
NOTE: Spacers may be needed
in between the upright and
door mount bracket to reach
the thick portion of the door
(See Figure 4).
DOOR MOUNT
INSTALLATION
STEP 5
Refer to Figure 5 to determine
door mounting hole locations.
Transfer these dimensions to your
door from the bottom and mark
the hole locations. Pre-drill these
holes on the back side of your
cabinet door, making sure NOT to
drill through the door.
3
32
STEP 6
Remove the door mount
brackets and screw to inside of
cabinet door with #6 x 1/2" flat
head screws.
NOTE: Line up door mount
bracket to cabinet door by
aligning door mount bracket
with the marks you made in step
5 (See Figure 6).
INSTALLATION INSTRUCTIONS: 4WC DOUBLE 30 QT WASTE CONTAINER WITH BLUM® SOFT-CLOSE
FIG. 4
FIG. 5
1)
Make sure that your unit is securely installed into your cabinet. Remove the cabinet door and
hinges to begin to mount your door.
2)
Measure from frame to top bracket slot ________
Using the (4) provided screws and nuts, attach the L-Brackets to your slide.
Note: Depending on your particular basket design L-Bracket will mount on either inside or
Measure from frame to bottom bracket slot ________
outside of wire.
FIG. 6
Inside wire shown
3a)
Attach the door brackets to the outside of the L-brackets using the (4) provided screws.
2.
Measure Opening Height ________
Measure Door Height ________
Height Difference ________
Divide Difference by 2 ________
3b)
Cada puerta de gabinete es d
con la porción gruesa de la puerta
dañen su puerta.
Chaque porte d'armoire est différ
3.
la partie épaisse de la porte de l'a
If your door is larger than cabinet opening,
add the divided difference you found in
à travers et endommager votre p
step 2 to the measurements in step 1. If
your door is smaller, subtract the divided
difference from the measurements in step 1.
Top Measurement ________
Bottom Measurement ________
Mark screw locations on
your door and pre-drill.
Be careful not to drill
3c)
Se proveen espaciadores de p
through the cabinet door.
dos para alcanzar la porción gruesa
Des espaceurs en plastique sont fo
pour atteindre la partie épaisse de
4)
Aplique cinta de doble lado a lo
soportes mientras trata de manten
poco, esto puede ser ajustado. La c
atornilla los soportes a la puerta de
Mettez du ruban adhésif double s
supports tout en essayant de main
tout à fait à niveau, tout cela peut
pendant que vous vissez les suppo
3
Publicidad
