Waring Commercial WDM120 Manual Del Usuario página 3

The drink mixer can be operated without engaging the ON/OFF
cup actuator by using the PULSE
switch will operate at whatever speed the 3-speed switch is set to.
The PULSE switch will only operate while pressed forward or
backward. Keep a firm grip on the cup while using PULSE
Your Waring Commercial Drink Mixer is supplied with 2 agitators,
®
1 standard and 1 "butterfly" (with the movable flaps) per spindle.
To switch agitators, simply hold the spindle shaft with one hand
and turn the agitator in a clockwise direction. This will loosen
the screw, and you can unscrew to remove. Insert replacement
agitator and screw bottom screw back in. Tighten by turning the
agitator in a counterclockwise direction. Only use a standard
metal mixing cup with the standard agitator.
CLEANING & MAINTENANCE INSTRUCTIONS
1. Rinse container thoroughly under running water. Add 8
ounces of clean rinse water to container. Place container in
normal operating position on mixer and run on HI (III) speed
for two (2) minutes. Empty container.
2. UNPLUG MIXER POWER CORD FROM ELECTRICAL
OUTLET.
3. To remove bottom cup supports (C), simply push each
support up then pull out.
4. To remove the upper cup holders (D), hold the notches on
both sides of the holder, then pull directly out from the base.
5. Wash, rinse, and sanitize the container supports, ON/OFF
switch actuator, and container. Sanitize these parts by
immersing in sanitizing solution for two (2) minutes. Shake
excess moisture and allow parts to air dry.
toggle switch. The Pulse
4
6. Working from the top down, wash, rinse, and sanitize the
portion of the mixer housing situated directly over the
container and the portion of the spindle above the agitator,
using absorbent wiping cloths moistened with cleaning
.
solution, rinse water and sanitizing solution.
7. Reassemble ON/OFF switch actuator, and container
supports to mixer housing by reversing steps 3 and 4.
8. For each spindle, wash, rinse and sanitize the bottom of the
spindle and the agitator (illustrations A and B) as follows:
Plug the Waring
electrical outlet.
Add 8 ounces of washing solution to container and place in
normal operating position on mixer.
Run on HI (III) speed for a minimum of two (2) minutes.
Empty container and repeat two-minute run with 8 ounces
of water.
Empty container, and repeat two-minute run with 8 ounces
of sanitizing solution.
Empty container. Run motor for a few seconds with empty
container in normal operating position to spin off any excess
moisture. Do not rinse container, spindle or agitator after
sanitizing is completed. Allow all parts to air dry.
Wash, rinse, and sanitize as outlined above prior to initial use, and
whenever mixer will not be used again within a period of one hour
to avoid bacteria buildup.
Surfaces of the mixer housing that are outside of the food contact
areas may be cleaned as required, using wiping cloths moistened
with cleaning solution, rinse water and sanitizing solution.
UNPLUG POWER CORD FROM ELECTRICAL OUTLET BEFORE
CLEANING HOUSING. Prevent liquid from running into housing
by wringing all excess moisture from wiping cloths before using
them.
Washing solutions based on non-sudsing detergents and
chlorine-based sanitizing solutions having a minimum chlorine
concentration of 100 PPM are recommended.
Commercial Drink Mixer cord into
®
5