Installation; Mounting The Pdu - Tripp-Lite PDUMH20HVNET El Manual Del Propietario

Installation

Mounting the PDU

The PDU supports five primary mounting configurations: 1U Rack, 0U Rack (Vertical), Wall,
Under-Counter and Reduced-Depth.
Note: Regardless of configuration, the user must determine the fitness of hardware and procedures before mounting. The PDU
and included hardware are designed for common rack and rack enclosure types and may not be appropriate for all applications.
Exact mounting configurations may vary. Screws for attaching the mounting brackets to the PDU are included. Use only the screws
supplied by the manufacturer, or their exact equivalent (#6-32, 3/16" flat head).
1-1
1U Rack Mounting: Use 3 screws
attach each of the 2 longer mounting
brackets
B
can mount the PDU in a recessed
position by attaching the mounting
brackets so they extend beyond the front
panel of the PDU. Mount the PDU in the
rack by inserting 4 user-supplied screws
through the mounting brackets
C
into the mounting holes of the rack rails.
1-2
0U Rack Mounting: Use 3 screws
attach each of the 2 shorter mounting
brackets
B
the PDU vertically by inserting 2 or more
user-supplied screws
mounting brackets
points in the rack or rack enclosure.
1-3
Wall Mounting: Use 3 screws
attach each of the 2 shorter mounting
brackets
B
the PDU to the wall by inserting 2 or
more user-supplied screws
mounting brackets
mounting points.
1-4
Under-Counter Mounting: Use 3 screws
to attach each of the 2 shorter
A
mounting brackets
shown. Mount the PDU under the counter
by inserting 2 or more user-supplied
screws through the mounting brackets
C
and into secure mounting points.
D
18-11-320-933681.indb 3
A
to the PDU as shown. You
D
A
to the PDU as shown. Mount
through the
C
and into mounting
D
to
A
to the PDU as shown. Mount
through the
C
and into secure
D
to the PDU as
B
to
A
and
1-1
to
A
1-2
A
1-3
A
1-4
3
A
RESET
STATUS CONFIG
B
RESET
CONFIG
STATUS
D
C
B
D
B
D
B
D
C
1/25/2019 2:54:57 PM
C
C