Rev-A-Shelf RAS-FD-KIT Instrucciones De Instalación página 3

STEP 4
Place frame inside cabinet
and position from adjacent
to side of cabinet opposite
the hinged door to allow
baskets to slide out without
obstruction.
NOTE: It may necessary to
place frame into cabinet at
an angle (See Fig. 4).
STEP 5
Securely attach (1) machine
screw (slotted hole) to
FRONT U-shaped bracket
upper slide then securely
attach lower slides to FRONT
U-shaped support brackets
with (4) machine screws
(See Fig. 5A & 5B).
STEP 6
Sit front of slide 1/4" back
from outside front of cabinet
and secure to face frame (or
sidewall) with (1) 1/2" wood
screw (See Fig. 6).
NOTE: Pre-drilling with a
3/32" bit for hardware
is recommended.
STEP 7
Attach U-shaped support
brackets to the cabinet floor
with the mounting holes
1-13/16" back from
outside front of cabinet as
shown with (4) 3/4" wood
screws (See Fig. 7).
FIG.
4
FIG. 5A
Upper height location
FIG.
6
1/4"
FIG.
7
INSTALLATION INSTRUCTIONS: TWO-TIER FILE DRAWER SYSTEM
FIG. 5B
1-13/16"
3