On/Off Switch - Poulan Pro SM132 Manual De Instrucciones

ON/OFF Switch
HOW TO START YOUR UNIT
_WARNING:
The trimmer head will
turn while starting the engine. Avoid any con-
tact with the muffler. A hot muffler can cause
serious burns.
HELPFUL TIP I
!f your engine still does not
I stait after foflowing these I
instructions, please Carl
1-800-554-6728.
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
,_ Starting Position
Primer Bulb
Choke
_Lever
Choke
position
decal
8. Pull starter rope sharply until engine runs.
but no more than 6 pulls. If the engine
doesn't start after 6 pulls (at the HALF
CHOKE position), move the choke lever to
the FULL CHOKE position and press the
primer bulb 6 times. Squeeze and hold the
throttle trigger and pull the starter rope 2
more times. Move the choke lever to the
HALF CHOKE position and pull the starter
rope until the engine runs. but no more than
6 pulis, if the engine doesn't start, repeat
procedure 2 additional times. NOTE: if
engine still doesn't start, it is probably
flooded. Proceed to STARTING A
FLOODED ENGINE.
9. Once the engine starts, allow it to run 10 se-
conds, then move the choke lever to OFF
CHOKE by aligning lever with position
shown on decal (see illustration below). AF
tow the unit to run for 30 more seconds at
OFF CHOKE before releasing the throttle
trigger. NOTE: If engine dies with the
choke lever in the OFF CHOKE position.
move the choke lever to the HALF CHOKE
position and pull the rope until engine runs.
but no more than 6 pulls.
1,
2.
3.
4.
Muffler
Set unit on a flat surface.
Move ON/OFF switch to the ON position.
Slowly press the primer bulb 6 times.
Move choke lever to FULL CHOKE by
aligning lever with position shown on de-
cal (see illustration below).
Choke
position
decat
5. Squeeze the throttle trigger fully and hold
through all remaining steps,
6. Pull starter rope handle sharply until en-
gine sounds as if it is trying to start, but do
not pull rope more than 6 times.
7. As soon as engine sounds as if it is trying to
start, move choke lever to HALF CHOKE
by aligning lever with position shown on de-
cal (see following illustration).
Choke
position
decal
STARTING A WARM ENGINE
1. Move ON/OFF switch to the ON position.
2. Move the choke lever to the HALF
CHOKE position.
3. Squeeze and hold the throttle trigger.
Keep throttle trigger fully squeezed until
the engine runs smoothly.
4. Pull starter rope sharply until engine runs.
but no more than 5 pulls.
5. Allow engine to run 15 seconds, then
movethe choke lever to the OFF CHOKE
position.
NOTE: if engine has not started, pull starter
rope 5 more pulls. If engine still does not run. it
is probably flooded.
STARTING A FLOODED ENGINE
Flooded engines can be started by placing
the choke lever in the OFF CHOKE position;
then, pull the rope to clear the engine of ex-
cess fuel. This could require pulling the starter
handle many times depending on how badly
the unit is flooded.
5