Activating Or Deactivating Features - Philips SonicPro 30 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

14
English
QuadPacer
1
2
4
3
SmarTimer

Activating or deactivating features

EasyStart
The QuadPacer is an interval timer that has a short
beep and pause to remind you to brush the 4 sections
of your mouth evenly and thoroughly. This SonicPro
toothbrush comes with the QuadPacer feature
activated.
The SmarTimer indicates that your brushing cycle is
complete by automatically turning off the toothbrush
at the end of the brushing cycle.
Dental professionals recommend brushing no less
than 2 minutes twice a day.
Note: If you press the power on/off button after you
started the brushing cycle, the toothbrush will pause.
After a pause of 30 seconds, the SmarTimer resets.
You can activate or deactivate the following features
of your toothbrush:
- EasyStart
- Brush head replacement reminder
- Pressure sensor
To activate or deactivate these features, follow the
instructions below:
Put the handle on the plugged-in charger.
1
2 Press and hold the power on/off button while the
handle remains on the charger.
3 Keep the power on/off button pressed until you
hear a single short beep (after 3 seconds).
4 Release the power on/off button.
- Triple tone of low-med-high means the EasyStart
feature has been activated. The battery level
indicator light will also blink green 2 times to
confirm activation.

Publicidad

Tabla de contenido
loading

Tabla de contenido