MIC7000 Illuminator
Notice!
If you are also planning to install the MIC sunshield,
insert only the rear center screw to hold the illuminator
accessory in position until you install the sunshield.
Tighten the screw on one side by two (2) turns. Tighten
the screw on the other side by two (2) turns. Tighten
the center screw by two (2) turns. Repeat until all
screws are tight.
Warning!
!
Total engagement is not complete until you tighten all
three (3) screws.
Bosch Security Systems
Install the MIC7000 Illuminator | en
2014.08 | 1.2 | F.01U.306.503
13