Changing The Battery; Clean Inline Filter; Clean Aerator - geberit 115.728.21.1 Instrucciones De Instalación

1. When battery is low, the sensor will display a contin-
uous signal until the battery is completely dead.
2. Remove the setscrew from the back of the spout and
remove the spout.
1. Shut off the hot and cold water lines.
2. Disconnect the hot and cold water lines from the sup-
ply lines.
3. Remove the filters from the connections and clean
them thoroughly of any debris.
4. Reinstall filters and connect the hot and cold water
lines to the supply pipes. Use Teflon tape on the
threads to ensure a leak-free joint. Tighten connec-
tions securely.
5. Turn water supply on.
1. Shut off the hot and cold water lines.
2. Remove aerator and clean thoroughly of any debris.
3. Install aerator using the wrench supplied with the
faucet.
4. Turn water supply on.

CHANGING THE BATTERY

3. Remove the old battery and replace with a new
Lithium CR-P2/6V battery.
4. Reinstall spout and setscrew.

CLEAN INLINE FILTER

CLEAN AERATOR

4
Geberit Exposed Electronic Faucet
Installation & Maintenance Instructions
Filters Location
© 0504
Tag # T311
964.143.00.0