Assembly - Uline H-1679 Manual Del Usuario

I. CAREFULLY UNPACK ALL ITEMS
1. Remove control panel from packing
foam. (See Figure 1)
Figure 1
II. ATTACH CONTROL PANEL
1. Feed excess cable into the control
panel head. Align three holes in control
panel with three holes on pallet truck
base. (See Figure 2)
Figure 2
2. Remove the two screws (one on each
side) to release the front panel. Carefully
open the front panel. (See Figure 3)
Figure 3
ASSEMBLY INSTRUCTIONS
3. Align mounting holes on pallet truck with
4. Insert and tighten 3 hex screws (H109)
5. Close front panel and secure with
7 of 62
mounting holes on control panel. (See
Figure 4)
Figure 4
with spring washers (H110) through
base of control panel with hex wrench
provided. (See Figure 5)
Figure 5
Hex Screw Hex Screw
(H109) (H109)
Washer
(H110)
2 screws. (See Figure 6)
Figure 6
0721 IH-1679