Front Panel - Tripp-Lite NetDirector B024-HU08 Guia De Inicio Rapido

Introduction

Front Panel

Model B024-HU08
Model B024-HU16
Key Component Description
Port For manual port selection*:
A
Selection
• Press a port selection pushbutton for less than two seconds to bring
Pushbuttons
the KVM, USB hub, and audio focus to the computer attached to its
corresponding port.
• Press a pushbutton for longer than two seconds to bring the KVM and
audio selection to the computer attached to its corresponding port.
• Press pushbuttons 1 and 2 simultaneously for 2 seconds to start Auto
Scan Mode (for details, see Owner's Manual section 11.4 Auto Scan
Mode).
• Press pushbuttons 7 and 8 simultaneously for 2 seconds to perform a
keyboard and mouse reset (for details, see Owner's Manual section
11.6 Keyboard/Mouse Reset).
• For independent switching, enable mouse emulation (see Owner's
Manual section 11.11.3 Mouse Emulation Control).
* For more details, see Owner's Manual section 9.2 Port Selection.
Port LEDs The Port LEDs are built into the Port Selection Switches. The KVM Port
B
LEDs are on the left. The USB LEDs are on the right.
KVM
• Illuminates dim orange to indicate the computer attached to the
corresponding port is up and running (On Line).
• Flashes to indicate Firmware Upgrade mode is in effect.
• Illuminates bright orange to indicate the computer connected to the
corresponding port has the KVM focus (Selected).
• Flashes to indicate the computer connected to the corresponding port is
being accessed under Auto Scan mode.
USB
• Lights green to indicate the computer connected to the corresponding
port is the one with access to the USB peripherals.
A B
A B
4
C D E F G H
C D E F G H