Intended Use; Symbols And Meanings; Safety Instructions - wolfcraft 3001000 Traducción Del Manual De Instrucciones Original

• The wood jointer is an attachment for mains- or battery-operated
drilling machines with a collar diameter of 43 mm.
• The wood jointer is suitable for milling profiles, slots and grooves.
• The maximum jointer speed of 5,000 rpm must not be exceeded.
• The correct direction of rotation of the jointer must be ensured during
assembly. It is therefore imperative to note the arrow on the device
housing, indicating the direction of rotation. The jointer is exclusively
designed for up-cut milling.
Warning of general danger
Read instructions/
information.
Wear safety goggles.
1. Ensure that your cutting tools are always sharpened. Blunt will give you
bad milling results and can " kick back" which could be dangerous
as well as overloading your power machine.
2. When removing a thick amount of material, then make several passes
( rough out and then make a fine cut ). It will save wear on your power
machine and cutting tools.
3. An even and gentle movement will prolong the life of your cutters,
prevents friction, burning on wood and overloading the motor.
• It is essential to comply with the safety instructions of the manufacturers
who made your drive machines.
• These appliances must conform to the VDE regulations. Appliances built
after 1995 must have CE certification.
t

Intended use

Symbols and meanings

Operating instructions

Safety instructions

17
Wear ear protection.
Wear a dust mask.
Pull out mains plug