Rampage JL Instrucciones De Instalación página 3

Installation Steps
4
Check hitch is level and centered on the vehicle.
Tighten hardware.
Installation Steps With L-Shaped Bracket
1
Remove two bolts securing L-Shaped bracket to the
bumper.
Remove two bolts securing L-Shaped bracket to rear
frame crossmember.
Save hardware and L-Shaped bracket for
re-installation.
2
Loosen the (8) factory bumper bolts to help aid in L-shaped
Bracket reinstallation.
There are two bolts on each side close to the frame and two
bolts on each side near the end of the bumper at the tire.
Full removal of the rear bumper is not required in most
cases.
3
Position the Tow Hitch in place on the rear crossmember,
lining up the corresponding holes.
Insert provided (2) 12mm Hex Bolts, (2) 12mm Lock
Washers and (2) 12mm Flat Washers in through the inner
slots on the Hitch, through the frame and thread into the
welded nuts on the Hitch.
Snug but do not fully tighten hardware.
NOTE: Actual application may vary slightly from illustrations.
Page 3 of 4