Installation Steps - Rampage 99-19 Universal Instrucciones De Instalación

Installation Steps

Identify the mounting locations for each bracket by looking under the driver side of the vehicle and finding the slots in the previously
installed primary running board. Note which holes correspond with the slots in the running boards.
1
Beginning at the driver side rear, slide a nut plate in place with the nuts facing upward. Align the holes in the nut plate with
If nut plate
is contact-
ing mounting
bracket or
gusset flip
so short side
is adjacent
to bracket
or gusset to
maximize
adjustability.
(See Picture)
2
Insure holes in the nut plate are visible through slots in running
3
NOTE: Actual application may vary slightly from illustrations.
Front
board
the slots in the running board.
Align slots in step with nut plate behind running
board. Insert bolt with washers to secure in place.
(4) Fasteners per step. Do not tighten at this point.
4
Page 2 of 3
Align holes in nut plate with slots
in board.
Auxillary running board aligned with previously
installed primary running board and bolt plate.