Installation Steps - Rampage Stepshield Instrucciones De Instalación

Installation Steps

NOTE: Actual application may vary slightly from drawings.
Open driver's door & clean Peel back 2" (5cm) of tape liner from
Stepshield mounting location. each end of driver side (LF) Stepshield.
1
2
Set Stepshield in place. Be sure the part is
centered along the horizontal surface and
not on the curved areas of the door frame.
If necessary, lift the door sealing gasket.
3
Remove tape liners.
Apply pressure to taped areas to secure.
4
5
Repeat steps 1 through 5 for the passenger side
(RF) Stepshield (and rear Stepshields if applicable)
Page 2 of 3