Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Tools Required
Box Wrench - 13MM
Pre-Installation Requirements
•
Remove Factory Doors - We recommend that you roll down your windows prior to removing the factory doors.
•
Step 1 Front and Rear doors: Locate wiring harness along with limiting strap.
•
Step 2 Unplug the wiring harness 3 connector under the instrument panel by pressing the tab at the top of the connector 1 and
pulling to disconnect. NOTE: If the red latch on the connector is locked, pull the red latch down. This will unlock the connector
tab, allowing the tab to be pressed down and enabling the harness to be disconnected.
•
Step 3 Locate the 2 hex bolts that are used to attach the factory door to the hinge. Use a T-50 TORX bit to remove the hex bolts.
Once the bolts are removed you can remove the door. Unhook the limiting strap 2, carefully lift the door out of the hinges. Be
careful as the doors are a bit heavy. Reattach the hex bolts on the doors, that way they wont get lost. Repeat this process for the
other doors.
Installation Steps
Door Strap/Harness location
Unplug the wiring harness
connector under the instru-
ment panel by pressing the tab
at the top of the connector and
pulling to disconnect.
NOTE: If the red latch on the
connector is locked, pull the
red latch down. This will un-
lock the connector tab, allow-
ing the tab to be pressed down
and enabling the harness to be
disconnected.
1
Remove the trim access door from the bottom of the B-pillar. Unplug
the wiring harness connector.
2
Ratchet and extensions -
13MM
NOTE: Actual application may vary slightly from illustrations.
Torx Bits - T50
4 Door Rear Door Removal ONLY
Page 2 of 5
Safety Glasses
Remove the hinge pin screws from the
upper and lower outside hinges (using
a #T50 Torx® head driver).
Publicidad
Tabla de contenido
