cecotec Ready Warm 5250 Swing Box Ceramic Manual De Instrucciones página 27

- To check the current time and setting temperature, press SET again.
- If the power switch is turned off or the light goes off, the time and day must be reset again.
• o Week scheduling
- Press to switch the appliance on..
1. Press to enter the weekly heating schedule. The
2. Press DAY to set the day you desire the heater to operate (d1, d2, d7...).
3. Press EDIT to select the number of periods you want to schedule (P1, P2, P6...).
4. Press TIME/ON to set the turn-on time (00, 01, 22- 23...). (Only hours can be set, not
minutes.)
5. Press TIME/OFF to set the turn-on time (00, 01, 22- 23...). (Only hours can be set, not
minutes.)
Note: the OFF time cannot be less than the ON time
6. Press and
7. Press OK to confirm the setting.
8. Repeat steps 3 to 7 to set the other heating periods for the same day.
9. Repeat steps 2 to 8 to set the other days of the week.
- Press to activate (
programme.
- Once all the settings have been saved and the programme is operating, press DAY / EDIT
TIME/ON and TIME/OFF to check the set time of each day and time period.
Note:
- When turn-on and turn-off time match, the appliance will be in standby mode.
- If no temperature is set, the default temperature is 23 ºC.
- When the room temperature is 23 ºC or above, the appliance will switch off or not turn on.
- If the power switch is turned off, the weekly settings will be deleted.
to set the temperature of this time period.
light up) or deactivate (
symbol will light up.
light off) the week scheduling
READY WARM 5250 SWING BOX CERAMIC
ENGLISH
27