Product Assembly; Control Panel; Operation - cecotec Ready Warm 5250 Swing Box Ceramic Manual De Instrucciones

4. PRODUCT ASSEMBLY

The product must be installed on a wall before operating. Do not use it unless it is properly
installed.
1. Drill two holes with a distance of 39.4 cm between them and 8 mm depth in the wall
2. where the product is going to be installed.
3. Insert the plastic stoppers in the holes and tighten them by screwing the screws provided
leaving them at a 10-mm distance from the wall.
4. Aligning the holes on the product's back with the screws on the wall, place the heater
against the wall and gently place it on the screws. Push the heater backwards until it is
safely fixed.

5. OPERATION

• The display will light up when the appliance is turned on.
• The product can be controled from the control panel.

CONTROL PANEL

1. Modes
2. Timer
3. Temperature adjustment
4. Window mode
5. Week scheduling
6. Eco mode
7. Max mode
6
5 7
4 3 2
READY WARM 5250 SWING BOX CERAMIC
ENGLISH
2
1
21