How To Recall 12 Readings In Memory Mode; Error Messages; Cleaning And Disinfecting; Battery Replacement - Microlife FR 100 Manual Del Usuario

Ocultar thumbs Ver también para FR 100:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7. How to recall 12 readings in Memory Mode

This thermometer can recall the last 12 readings.
• Recall mode AL: Press the START button 2 to enter
Recall mode when power is off. The memory icon «M»
will flash.
• Reading 1 - the last reading AM: Press and release the
START button 2 to recall the last reading. Display 1
alone with memory icon.
• Reading 12 - readings in succession: Press and
release the START button 2 consecutively to recall the
last 12 readings in succession.
Pressing and releasing the START button 2 after the last
12 readings have been recalled will resume the above
sequence from reading 1.

8. Error Messages

• Measured temperature too high AN: Displays «H»
when measured temperature is higher than 42.2 °C or
108.0 °F.
• Measured temperature too low AO: Displays «L» when
measured temperature is lower than 34.0 °C or 93.2 °F.
6
• Ambient temperature too high AP: Displays «H» in
conjunction with the « » when ambient temperature is
higher than 40.0 °C or 104.0 °F.
• Ambient temperature too low AQ: Display «L» in
conjunction with the « » when ambient temperature is
lower than 16.0 °C or 60.8 °F.
• Error function display AR: The system has a malfunction.
• Blank display AS: Check if the battery has been loaded
correctly. Also check polarity (<+> and <->) of the battery.
• Flat battery indication BT: If the steady battery icon is
the only symbol shown on the display, the battery should
be replaced immediately.

9. Cleaning and Disinfecting

Use an alcohol swab or cotton tissue moistened with alcohol
(70% Isopropyl) to clean the thermometer casing and the
measuring probe. Ensure that no liquid enters the interior of
the thermometer. Never use abrasive cleaning agents, thin-
ners or benzene for cleaning and never immerse the instru-
ment in water or other cleaning liquids. Take care not to
scratch the surface of the probe lens and the display.

10. Battery Replacement

This instrument is supplied with one lithium battery, type
CR2032. Replace with a new CR2032 battery when the
flashing battery symbol appears on the display BT.
Remove the battery cover by sliding it in the direction
shown. Remove the battery and replace with a new one BK.
Batteries and electronic instruments must be
disposed of in accordance with the locally appli-
cable regulations, not with domestic waste.

11. Guarantee

This instrument is covered by a 2 year guarantee from the
date of purchase. The guarantee is valid only on presenta-
tion of the guarantee card completed by the dealer (see
back) confirming date of purchase or the receipt.
• The guarantee covers the instrument. Batteries and
packaging are not included.
• Opening or altering the instrument invalidates the guarantee.
• The guarantee does not cover damage caused by
improper handling, discharged batteries, accidents or
non-compliance with the operating instructions.
Please contact Microlife-service.

Publicidad

Tabla de contenido
loading

Tabla de contenido