Mains Supply - Philips AJ3131/00 Manual De Instrucciones

MAINS SUPPLY

For users in the U.K.: please follow the instructions on page 4.
1. Check if the mains supply, as shown on the type plate
inside the battery compartment, corresponds to your local
mains supply.
2. If your set is equipped with:
• a voltage selector - found on the back of the set
• a frequency selector - inside the battery compartment
adjust these selectors to match with your local mains
supply and frequency.
3. Connect the mains plug into the wall socket. The mains
supply is now switched on and the numbers on the display
will start to flash. You will need to set the correct time.
4. To disconnect the set from the mains supply completely,
withdraw the mains plug from the wall socket.
Standby power consumption: ..................................................3W
6
POWER BREAKDOWN BACKUP
When a power failure occurs the complete clock radio will be
switched off. When the mains supply returns, the numbers on
the display will start to flash and you will need to reset the
correct time on the clock.
To retain the clock time and the set alarm time in the event of
an AC mains failure or disconnection, insert a 9 volt battery,
type 6F22 (not supplied) into the battery compartment: this will
act as a mains backup. However, the time will not be
illuminated on the clock display. Operation of the alarm and
radio are also excluded. For clarity, the battery backup is used
to retain the clock and alarm time only. As soon as the mains
supply returns, the display will indicate the correct time.
1. Insert the battery into the battery compartment.
2. Connect the mains plug to the wall socket.
• Replace the battery once a year, or as often as necessary.