Fein GRIT GIE Manual Del Usuario página 13

GIE.book Seite 13 Dienstag, 20. Juni 2006 8:45 08
GIE
Working with the machine (Figures 3+4).
Make sure that the protective cover (15) is
shut.
Check the gap size of the sanding rest and
make sure that both fastening screws (8) are
tightened.
Check the correct adjustment and tight seat-
ing of the eye protection.
Select the speed and switch the machine on.
Position the work piece on the sanding rest
and guide it with both hands.
Extraction device
The machine can be connected via the
sleeve (17) to a dust extraction system.
Repair and customer service.
Repairs may be carried out only by quali-
fied persons in conformity with the valid
regulations.
For repairs, we recommend our FEIN customer
service centre, the FEIN authorised service cen-
tres and FEIN agencies.
Carry out the following maintenance daily:
Blow out the ventilation slots (10) at the
motor housing and the marked locations
with compressed air (see instruction label).
Remove any deposits from within the hous-
ing.
Warranty and liability.
The warranty for the product is valid in accord-
ance with the legal regulations in the country
where it is marketed.
In addition, FEIN also provides a guarantee in
accordance with the FEIN manufacturer's guar-
antee. For further details on this, please contact
your specialist dealer, your national FEIN repre-
sentative, or the FEIN customer service centre.
Declaration of conformity.
The GRIT Corp. declares itself solely responsible
for this product conforming to the documents
and standards given on the last page of this
Instruction Manual.
Environmental protection, disposal.
Stationary machines should be sorted for envi-
ronment-friendly recycling in accordance with
national laws.
Noise emission values.
Measured A-weighted sound power level L
(re 1 pW), in decibels: 85
Measuring uncertainty K
wA
A-weighted emission pressure power level
measured at the workplace L
decibels: 74
Measuring uncertainty K
pA
REMARK: The sum of the measured emission
value and respective measuring inaccuracy rep-
resents the upper limit of the values that can
occur during measuring.
Wear ear protection!
For measurement values obtained according to
the respective product standard, see the last
page of this Instruction Manual.
EN
wA
, in decibels: 3
(re 20 µPa), in
pA
, in decibels: 3
13