Alesis MultiMix 8 FIREWIRE Manual De Inicio Rápido Para El Usuario página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

2. CONNECT THE MULTIMIX FIREWIRE TO THE COMPUTER
Connect your microphones and line-level sources to the MultiMix FireWire
Connect your output devices - headphones or speakers, or both - to the MultiMix FireWire. Turn their
volume down to zero
Turn on the MultiMix FireWire
Connect the Firewire cable to both the MultiMix FireWire and your computer
Turn your computer on
NOTE: If your computer "hangs" when following this procedure, turn off both the mixer and the computer. Try
turning on the computer first. Turn on the MultiMix FireWire only after your computer has completely booted up.
3. START YOUR COMPUTER'S AUDIO RECORDING APPLICATION
Within the recording application, select the MultiMix FireWire as the recording and playback device
Adjust the MultiMix FireWire's sample rate (44.1kHz or 48kHz) and buffer sizes as appropriate
Assign
one or more MultiMix FireWire inputs and begin recording
On the MultiMix FireWire, assign the "2-TK" output from the computer to the monitor mix
Raise the monitoring level (headphones or monitor speakers) on the MultiMix FireWire to listen back
See the Reference Manual for additional details.
Raise or lower the trim knobs and volume sliders on the MultiMix FireWire to achieve a
strong signal which does not distort (clip)
Use the equalizer to sculpt the sound
To record the signal along with the built-in effects or AUX bus effects, record the master
fader signal. Individual channel signals include EQ but do not include effects

Publicidad

Tabla de contenido
loading

Tabla de contenido