Uline THINAIR H-7860 Guia De Inicio Rapido página 2

13⁄"
5. Attach base plate at the four corners to smooth wall.
Use one of two knockouts provided for service entry
on back of base plate. If using surface wiring, use
knockout in right side of cover. Use knockout gasket
included around conduit for water seal. (See Figure 2)
6. Connect the 120 V dryer to a dedicated branch
circuit not exceeding 20 Amp.
7. Secure electrical wiring to terminals as indicated by
the schematic affixed to blower housing. An identified
ground connection point is supplied on the base
plate for the equipment ground wire.
8. Carefully replace cover by inserting top over
bracket and tilting downward. Use tamperproof
bolt mentioned in Step 2. Restore power and test for
proper operation. In multiple installations, make sure
the serial number marked on the inside matches the
cover number.
OUTSIDE
Using a soft cloth or sponge and mild soap or detergent,
gently wash the cover (including air inlet holes) with
lukewarm water to loosen dirt and grime.
INSIDE
CAUTION! Shut off power to the dryer at the
service connection. Cleaning should be
performed by qualified service personnel.
PAGE 2 OF 12
INSTALLATION CONTINUED
13⁄"
4"
MAINTENANCE
8⁄"
6½"
3¼"
Surface Electrical Inlet
(1) 7/8" Dia. Holes
Electrical Inlets
(2) 7/8" Dia. Holes
1⁄"
3⁄"
6¼"
9. Apply a bead of silicone sealant around the
outside of the cover at the wall to protect the dryer
from internal corrosion caused by wash water and
cleaning solutions.
WARNING! To reduce the risk of fire, electric
shock or injury, use dryer only in the manner
intended by the manufacturer.
Before servicing or cleaning unit, switch off
power at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally.
When the service disconnecting means cannot
be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
NOTE: With normal use, the dryer will require
cleaning once a year. Heavier usage requires
more frequent cleaning. Lint on the air inlet,
pre-filter or other internal parts of dryer will reduce
efficiency and shorten the life of the working parts.
1. Using the tamperproof wrench provided, remove the
cover by unscrewing the tamperproof bolt from the
bottom of cover and lift upwards.
2. Use a small, soft brush to gently clean all parts. Unclip
pre-filter, rinse with water and dry completely. Re-install.
Surface Mount
Knockout Gasket
11⁄"
8⁄"
3¼"
Figure 2
0121 IH-7860