Canon imageCLASS X C1538P Guía De Configuración página 2

Configuring the Initial Settings
Specifying the Basic
1
En
Settings
When you turn on the machine for the first time, the
Setup Guide starts up on the operation panel. Perform
Es
the initial machine setup by following the on-screen
instructions.
Pt
1.
Select the language.
2.
Select the time zone.
3.
Set the current date/time.
Specifying the Security
2
Settings
Set an Administrator password to increase machine
security.
1.
Check the message and press
2.
Select <Yes>.
To continue without setting a password, select
<No> and proceed to "Specifying the Network
Settings".
3.
Enter a password and select <Apply>.
Enter the same password again and select <Apply>.
4.
Check the message and press
Operation panel
.
.
Specifying the Network
3
Settings
Specify the settings for connecting the machine to a
network. Before proceeding, check that the computer and
router are correctly connected to the network.
Wired LAN
1.
Select <Wired LAN>.
2.
Connect the LAN cable.
Wait a few minutes while the machine's IP address
is automatically set.
Wireless LAN
The example described in this document is for the <SSID
Settings>. See the User's Guide for information on other
configuration procedures.
1.
Check the router's "SSID" and "Network
key".
SSID
: XXXXXXXXXXXX
Network key
: XXXXXXXXXXXX
2.
Select <Wireless LAN>.
3.
Check the message and press
4.
Select <SSID Settings>.
5.
Select <Select Access Point>.
2
.