Mounting The Tonearm Base To The Player - Technics SH-TB10-S Instrucciones De Funcionamiento

Mounting the tonearm base to the player

Attention
z Work on a stable, level surface.
(1) Disconnect the control unit
connection cable, phono cable,
earth lead, etc.
(2) Remove the turntable.
(See "To remove the turntable"
(  15) in the SL-1000R
Operating Instructions)
(3)Remove the insulators.
z Place two packing cushions under
the main unit to lift, and turn the
insulators in the direction shown
in the figure below.
Packing cushion
(SL-1000R)
(4) Put the main unit vertically on
a side on the protective sheet
that came with the main unit.
z Make sure there are
no protruding objects,
such as screws, under
the protective sheet.
z Be careful the main
unit does not lose
balance and tip over.
Protective sheets
04
English
(12)
(5) Using the accessory hex wrench,
remove the turntable unit
mounting screws. (The seven
locations indicated in the figure
below)
(6) Place one packing cushion under
the main unit to put it at an
angle. Using the accessory hex
wrench, remove the remaining
turntable unit mounting screws.
(The two locations indicated in
the figure below)
Protective sheets
(7) Place two packing cushions
under the main unit to lift.
Packing cushion
(SL-1000R)
(8) Tighten the detachable handle
screws into the detachable
handle mounting holes on the
turntable unit. Slowly lift the
turntable unit to remove.
z Remove carefully to avoid catching
the control unit connection cable
in the cabinet and the like.
Detachable handle
mounting hole
Attention
z Tighten the detachable handle
by turning it 5 or more times.
If you have tightened it until the
end, loose a little bit.
Do not tighten it firmly.
(9) Remove from the cabinet the
cover at the location where the
tonearm will be mounted.
z Using the accessory hex wrench,
remove the two mounting
screws.
z Depending on the tonearm
type (short type or long
type), its mounting location is
predetermined. (  Page 8)
Cover
z To remove the cover, lift it
straight up.
English
05
(13)