Technics SH-TB10-S Instrucciones De Funcionamiento página 8

Mounting the tonearm base to the player
(10) Mount your tonearm to
the tonearm base.
z Refer to your tonearm leaflet.
(11) Mount the tonearm base to
the turntable unit.
z Mount in the appropriate location.
z Align the location of the pin
and screw holes on the tonearm
base with that of the pin hole
and screw holes on
the turntable side, and tighten
the screws (three locations) with
the hex wrench.
Insert the pin on the tonearm base
into the pin hole to position.
06
English
(14)
(continued)
(12) Tighten the detachable handle
screws into the detachable
handle mounting holes on
the turntable unit and slowly
mount the turntable unit to
the cabinet.
z Mount by taking care not to
catch the control unit connection
cable in the cabinet and the like.
Pass the control unit
connection cable through
the hole on the cabinet.
Washer
Screw
(13) Place one packing cushion
under the main unit to put
it at an angle to tighten the
turntable unit mounting
screws with the accessory
hex wrench. (The two
locations indicated in the
figure below)
Protective sheets
(14) Put the main unit vertically on
a side on the protective sheet
that came with the main unit.
z Make sure there are
no protruding objects,
such as screws, under
the protective sheet.
z Be careful the main
unit does not lose
balance and tip over.
Protective sheets
(15) Using the accessory hex
wrench, tighten the turntable
unit mounting screws.
(The seven locations indicated
in the figure below)
z Re-check that the screws at all
nine locations, including the two
tighten in step (13) are firmly
tighten.
(16) Attach the insulators to the
unit.
z Place two packing cushions
under the main unit to lift,
and turn the insulators in the
direction shown in the figure
below.
Packing cushion
(SL-1000R)
(17) Fitting the turntable.
(See "Fitting the turntable"
(  15) in the SL-1000R
Operating Instructions)
English
07
(15)