Samsung DA68-03015D-10 Manual Del Usuario página 17

SETTING UP THE REFRIGERATOR
DOORS
If your entrance won't allow the refrigerator to pass
easily through it, you can remove the doors.
Separating the water supply line from the
refrigerator
1. Pull the two water lines (which are in the Fixer)
out to the front.
2. Remove two water lines (White one is for water
and the other one is for ice) by pressing the
coupler ( 1 ) and pulling the water line ( 2 ) away.
Make sure the
color of the water
CAUTION
lines match.
When reconnecting the supply hoses,
make sure the same colored hoses are
CAUTION
inserted with each other.
Reattaching the Water Supply Line
1. The Water Line must be fully Inserted to the
centre of transparent coupler to prevent water
leakage from the dispenser.
2. Insert the 2 clips in the install pack and check
that each clip holds the line firmly.
DA68-03015D-10.indb 17
( 1 )
( 2 )
English - 17
Center of Transparent coupler
Clip A (1/4")
(6.35 mm)
Do not cut the water line.
Gently separate it from the coupler.
Keep the clips out of the reach of children
and make sure that children do not play
CAUTION
with them or put them into their mouths.
DISASSEMBLE THE FREEZER
DOORS
1. Disconnect the power cord, and remove 2
cover screws using a Phillips screwdriver ( 1 ).
Then open the refrigerator door and pull
the hooks on the sides to loosen the cover
( 2 ).
Lift up the cover and towards you to
detach it ( 3 ).
- Detach the hinge cover with the door open and
then close the door once the hinge cover has
been detached.
( 1 )
( 2 ) ( 3 )
2017. 7. 7. 2:18