Changing The Rotation Direction; Emptying The Collector Box; Overload Protection; Restart Prevention - Deltafox DG-ESS 2844B Traducción Del Manual De Instrucciones Original

5. To start, now press the on/off
switch (6), button "I".
The operating mode selection
switch locks into place.
6. Place your chopping material in
the fill hopper ( 3). The mate-
rial is drawn in and chopped.
7. To switch off, press the "O"
button on the on/off switch (6).
The shredder will continue to run
immediately after switching off.

Changing the rotation direction

The rotation direction can be changed.
1. Switch the device off and wait
for it to come to a standstill.
2. Move the direction switch (1) to
position "II" (reverse).
3. To start reverse, press and hold
the "I" button on the on/off
switch (6). The device is now in
inching mode.
The jammed chopped materials are freed.
4. To continue chopping, release
the "I" button on the on/off
switch (6). Wait until the appli-
ance has stopped.
5. Now, move the direction switch
(1) to the "I" position, then turn
the appliance back on. (see
section "Operation/switching
on/off").
The reverse function is only pos-
sible if the housing plate (
connected and installed correctly.

Emptying the collector box

Do not leave it until too late to
empty the collector box. Remem-
ber that the collector box fills un-
evenly under the ejector opening.
1.
2.
3.
4.
5.

Overload protection

In the event of overload, e.g. due to
branches that are too thick, the equip-
ment automatically switches off.

Restart prevention

After switching off automatically as a
result of overload, the equipment will not
restart automatically.
To switch back on:
1. Let the engine cool down
2. Move the direction switch (
"I" position.
7) is 3. Press the reset switch (
4. Switch the device back on.
Turn the device off.
Unlock the collection box (11) by
moving the safety switch ( 14)
to the bottom position
Remove the collection box (11)
from the retainer plate (9) and
empty it.
Make sure that the area around
the safety switch ( 14) is free of
wood chippings before you reat-
tach the collector box (
Put the collection box back
in place and move the safety
switch (14) up as far as it will go
(top position).
GB
.
11).
A
1) to the
A
2).
A
29