Placing In Operation - Monti MBX Bristle Blaster Electric 3200X Manual De Instrucciones

Operating instructions
GB
5.

Placing in operation

Application:
This tool is used for the removal of corrosion and coatings, and for producing a rough surface profile (anchor profile)
using a specially developed Bristle Blaster
1. Interrupt supply of power and then fasten
23 mm belt correctly to the tool using the related adapter system
(pay attention to direction of travel) and the related serrated lock
washer and screw. See Fig. 1 and Fig. 2
®
2. For MBX Bristle Blaster
®
MBX
40 mm "stainless steel" accelerator bar.
3.
Before you plug the tool into a socket, you must check that it
is possible to actuate the switch correctly and that the switch
returns to the "OFF" position when you press on the rear part of
the switch. To start the tool, you must release the rear part of the
switch and push it forward. You must then release the front part
of the switch so that it engages. To stop the tool, you must press
the rear part of the switch. The switch then jumps to the "OFF"
position. Prior to plugging into a socket, always ensure the switch
is not in the "ON" position.
4.
Hold tool by the tool body and the vertical handle at the same
time.
5. To obtain the best performance, it is to be ensured the accelera-
tor bar is guided close to the surface to be machined. If the accel-
erator bar is too far from the surface, the performance will drop
significantly. See Fig. 3. For a more detailed description of the
function of the MBX
www.monti.de
6. Only work using minimum contact pressure. Excessive contact
pressure will limit the performance.
7. In all circumstances, prevent the entry of water into the tool.
For more information please contact info@processaids.in or visit www.processaids.in
18
®
belt.
MBX
®
23 mm stainless steel belt only use
® ®
see the DVD supplied or
Bristle Blaster
® ®
Bristle Blaster
® ®
MBX Bristle Blaster Electric 3200X
Fig. 1
Fig. 2
Fig. 3