Berkel B9-SLC Manual Del Operador página 11

CLEANING THE BLADE
Use­protective­gloves­and­concentrate­on­the­job­at­hand.­DANGER!­Make­sure­thickness­control­
knob­is­fully­to­the­right,­so­the­gauge­plate­covers­the­knife.
1. Press a damp cloth on the surface of the blade
and­move­it­slowly­from­the­center­to­the­edge,­as­
shown­in­the­picture,­on­the­side­of­the­blade­cover­
and on the other side.
2. Sanitize and dry in the same way using a dry cloth.
3.­ Repeat cleaning both front and back of knife with
clear water.
4. Always­move­from­the­center­outward.­NEVER­
MOVE­YOUR­HAND­TOWARDS­THE­EDGE­
OF­THE­KNIFE.­Sanitize­and­allow­to­dry.
CLEANING THE RING GUARD
1. Fold­a­cloth­wipe­that­has­been­submerged­in­fresh­detergent­solution­and­work­it­between­the­
ring­guard­and­the­knife,­starting­at­the­base­of­the­ring­guard.­Carefully­work­the­cloth­around­
the­knife,­cleaning­the­edge­of­the­ring­guard­and­edge­of­the­gauge­plate.­USE­
EXTREME CAUTION.
2. Sanitize and allow to dry.
CLEANING THE BODY OF THE MACHINE
1. Clean the machine body with a damp cloth or a
sponge rinsing frequently with hot water and cleaning
solution. Rinse with hot water. Sanitize and let
air dry.
2. Clean­also­the­gauge­plate­and­the­indexing­knob.­
While doing this operation pay attention to the knife.
Don't open the gauge plate or you risk to be cut!
CLEANING THE COMPONENTS IN THE BASE
The­components­contained­in­the­base­do­not­need­any­special­cleaning;­occasionally­remove­the­dust­
that can accumulate in the end area of the carriage and of the thickness plate regulation.
WARNING
BK45777 (01-21) o /o m • 11
wner peraTor anUal