Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
Cutting the opening
Cut out a 1 3/4 in. hole on the counter top for the drain.
Please refer to the cutout template (D).
NOTE:
To avoid possible damage to the cabinet, cut
the counter top before installing it to the cabinet.
3
Installing the pop-up drain
Unscrew the drain body (1) from the pop-up drain assembly (B)
tail piece (2).
Place the mounting ring (C) under the center of the vessel sink (A)
top where it will align with the cutout.
Slide the rubber gasket (3) to the top of the drain body (1) as shown.
Install the drain body (1) through the vessel sink (A).
Slide the rubber mac washer (4) up to the drain body (1), and
screw the retaining nut (5) onto the drain body (1).
From under the countertop, screw the tail piece (2) onto the
drain body (1).
Tighten the drain assembly retaining nut (5) by hand until it
stops turning, making sure that all silicone gaskets are used
and in their proper places.
Turn the retaining nut (5) half a turn with a wrench for nal
tightening.
CAUTION: Do not overtighten the drain assembly, as
this may cause the bowl to forcefully crack during
installation or at some time in the future.
NOTE: It may be necessary to cut part of the tail piece
or part of the horizontal leg in order to t existing plumbing.
2
D
4
Positioning the sink
Carefully, position the vessel sink (A) so that the drain hole
lines up with the cutout.
3
4
5
A
1
A
C
2
Publicidad
Tabla de contenido
