Chapter 2: Connection; Overview - Cisco Linksys WAPPOE Guia Del Usuario

Connection
Chapter:Connecton

Overview

This chapter gives instructions on how to connect the Power Over
Ethernet Kit. Once connected, the Kit will transmit data and power over
the Ethernet network cable to your remotely located network device.
The diagram shows an example of how the Kit can be connected to a
wired switch and a wireless access point.
Network
Workgroup
Switch
To connect the Kit to a device with a conventional power port, proceed
to the section, "Power on a Device that Uses a Standard Power Adapter. "
To connect the Injector to a device that supports inline power, proceed
to the section, "Power on a Device that Uses Inline Power. "
PowerOverEthernetAdapterKt
Power Adapter
(24V typical)
Power Cable
Power Over Ethernet
Ethernet Cable
Injector
Up to 328 feet
(100 m)
Chapter
Power Cable
Splitter
Wireless
Access Point