Using The Headphones - Audio-Technica ATH-AP2000Ti Manual Del Usuario

■ Using the headphones

Slider
Earpad
A2DC connector
plug
Balanced cable (1.2 m
(3.9') / 4.4 mm (0.17")
gold-plated balanced
Cable (1.2 m (3.9') / 3.5
mm (1/8") gold-plated
Cable (3.0 m (9.8') / 3.5
mm (1/8") gold-plated
LEFT/RIGHT
1. Connect the connector plug of the included cable to the
connector jack of the headphones.
• Do not use a cable other than the supplied detachable cable.
2. Lower the volume on the device you intend to use, then
connect the ''Input plug'' to the device's headphone jack.
3. Fit the earpads over your ears with the side marked "L"
over your left ear and the side marked "R" over your right
ear.
■
How to replace the detachable cable
The detachable connector is
very delicate. Only pull or
attach in a straight motion to
prevent malfunction.
• How to detach the cable
Hold the connector and pull
straight out in the direction
shown by the arrow.
• How to attach the cable
Plug the left connector or
right connector in as shown in
the illustration. Please plug
the connector in until it clicks.
■ Specifications
•Type: Closed-back dynamic •Driver: 53 mm •Sensitivity: 100
dB/mW •Frequency response: 5 to 50,000 Hz •Maximum input
power: 2,000 mW •Impedance: 44 ohms •Input jack: A2DC
connector jack •Weight (without cable): Approx. 300 g (10.5 oz)
•Included accessories: Cable (1.2 m (3.9') / 3.5 mm (1/8")
gold-plated stereomini-plug (L-shaped)),Cable (3.0 m (9.8') / 3.5
mm (1/8") gold-plated stereomini-plug (L-shaped)), Balanced
cable (1.2 m (3.9') / 4.4mm (0.17") gold-plated balanced plug (5
pole / L-shaped)), 6.3 mm (1/4") stereo adapter, Case, Cleaning
cloth
•Sold separately: Balanced cable, Cable, Earpads
For product improvement, the product is subject to modication
without notice.
plug (5 pole)
stereo mini-plug)
stereo mini-plug)
2
Headband
LEFT/RIGHT
Arm
Housing
A2DC connector jack
Input plug
Cable
Headphone
JA
EN
FR
DE
IT
ES
PT
RU
SC
TC
KO
Pin