Introduction; Device Description; Scope Of Delivery; Intended Use - Scheppach BTS 900 Manual Del Usuario

1. Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
We recommend:
Read through the complete text in the operating instruc-
tions before installing and commissioning the device.
The operating instructions are intended to help the
user to become familiar with the machine and take
advantage of its application possibilities in accord-
ance with the recommendations.
The operating instructions contain important infor-
mation on how to operate the machine safely, pro-
fessionally and economically, how to avoid danger,
costly repairs, reduce downtimes and how to in-
crease reliability and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information. The machine can only
be operated by persons who were instructed con-
cerning the operation of the machine and who are in-
formed about the associated dangers. The minimum
age requirement must be complied with.
In addition to the safety notices contained in this operat-
ing manual and the particular instructions for your coun-
try, the generally recognised technical regulations for the
operation of identical devices must be complied with.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

2. Device description

1 Locking screw for grinding/sanding table
2 Angle scale
3 Suction connection
4 Base plate
5 Allen screw
6 Grinding belt
7 Stop rail
8 Knurled screw for grinding/sanding belt adjust-
ment
9 Support leg
10 Grinding/sanding belt tensioner
11 Grinding/sanding disk
12 On/Off switch
13 Cross stop
14 Grinding/sanding table

3. Scope of delivery

• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, store the packaging until the warranty
period has expired.
Attention!
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swallow-
ing and suffocation!
• Belt/Disc Sanding machine
• Cross stop
• Grinding/sanding table
• Grinding belt
• Grinding disc
• Operation Manual

4. Intended use

The belt and disc sander is used for sanding all types
of wood, depending on the size of the machine.
The machine meets the currently valid EU machine
directive.
• The manufacturer's safety, operation and main-
tenance instructions as well as the technical data
given in the calibrations and dimensions must be
adhered to.
www.scheppach.com
GB | 19