Publicidad
STEP 1
Flip the unit upside down. Pull
the soft-close slide set into the
open position and locate the
triggers on the left and right
side (See Fig 1). Press and hold
the triggers either up or down
to remove the slide set. Set
the wood frame to the side.
After you remove the slides,
the soft-close mechanism will
be in the open position. Press
the trigger and reset it to the
closed position.
STEP 2
Place the template inside
the wall cabinet. Position the
template so the front edge
is flush with the front of the
cabinet frame and centered
(See Fig 2).
STEP 3
Using an awl and rubber
mallet, punch the hole
locations identified by the
smaller black circles on the
template (See Fig 3).
STEP 4
With a 3/32" drill bit, pre-drill
through the (4) marked hole
locations labeled "Pre-drill for
wood screw application". Secure
slide set to cabinet floor using the
(4) wood screws provided
(See Fig 4).
3
32
STEP 5
Re-attach the wood frame to
the slides. Align the frame and
push to the closed position.
NOTE: Be sure the ball-bearing
race tracks are placed at the
front of the slide channels.
STEP 6
Proceed to page 4 at this time
for door mounting instructions.
2
INSTALLATION WITH WOOD SCREWS
Customer Service: 800-626-1126 | rev-a-shelf.com
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
WOOD SCREWS FROM
TOP OF SLIDE ASSEMBLY
(4 TOTAL)
Publicidad
