Publicidad
STEP 1
Place the template inside of
the wall cabinet. Position the
template so the front edge
is flush with the front of the
cabinet frame (See Fig 1).
STEP 2
With a 3/8" drill bit, drill
through the (4) marked hole
locations labeled "Pre-drill here
for bolt application".
NOTE: Drill through the
cabinet floor (See Fig 2).
3
8
STEP 3
Place the unit over the top of
the holes and secure using the
(4) machine bolts (See Fig 3).
NOTE: Make sure the bolts
go through the holes from
the underside of the cabinet
up into the cabinet floor,
and secure them with a #2
Phillips head screwdriver. The
corresponding holes on the
slide set are threaded
for attachment.
STEP 4
Proceed to page 4 at this time
for door mounting instructions.
INSTALLATION INSTRUCTIONS: 448 SERIES PULLOUT WALL CABINET ORGANIZER W/ SOFT-CLOSE
INSTALLATION WITH MACHINE BOLTS
FIGURE 1
FIGURE 2
FIGURE 3
3
Publicidad
