Style selections SSDPS3272CLSV Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS
4. Set pivot jamb (A) on threshold (D) flush to the
inside edge of the lip. Use a level to ensure pivot
jamb (A) is plumb. Using a pencil (not included),
mark the five pre-drilled hole locations. Remove
pivot jamb (A). Using a drill (not included), drill
holes approximately 1-1/2 in. deep into each
marking.
NOTE: If installing into tile, use 1/4 in. masonry
bit (not included) and proceed to step 5a. If
installing into an acrylic or fiberglass shower
enclosure, use 1/8 in. drill bit (not included) and
proceed to step 5b.
5a. Tile installation: Insert wall anchors (FF) into
each drilled hole using rubber mallet (not
included). Place pivot jamb (A) back into
place. Tighten 1-1/2 in. screws (GG) with
Phillips screwdriver into each wall anchor (FF).
Hardware Used
FF
Wall Anchor
1-1/2 in. Screw
GG
5b. Acrylic and fiberglass installation: Place
pivot jamb (A) back into place. Tighten 1-1/2
in. screws (GG) with Phillips screwdriver into
each drilled hole.
Hardware Used
1-1/2 in. Screw
GG
4
5a
x 5
x 5
5b
x 5
6
A
Side
View
FF
GG
A
GG
A
A
D

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ssdps3672clsv09544140954413

Tabla de contenido