Care And Maintenance - Style selections SSDPS3272CLSV Manual De Instrucciones

FINAL ADJUSTMENTS
AA
A
Close door to verify that the magnetic strike (F) is flush from top to bottom with magnetic vinyl
strip (H).
If glass door is uneven, loosen screws from top of pivot bracket arm (AA). Remove glass panel from
frame. Using hex key (II), loosen bottom and/or top pivot pins. Reposition pin and then tighten using
hex key (II). Do not overtighten pins. Important: Do not adjust pins while door is still in frame. This
will cause glass panel (B) to slip and fall.
If magnetic vinyl strip does not make contact with magnetic strike, you can adjust the magnetic vinyl
strip and/or magnetic strike.
Once all adjustments are made, caulk all vertical seams. Allow 24 hours for caulk to dry before using.

CARE AND MAINTENANCE

• Do not use abrasive cleaners or metal scrapers.
• Use a squeegee after each use to prevent water spotting.
• Use any non-ammonia based glass cleaner.
II
B
10
H
B
F E