Maintenance And Cleaning; Noise/Vibration Information - Würth BS 14-A Power Traducción Del Manual De Instrucciones De Servicio Original

OBJ_BUCH-1566-002.book Page 13 Tuesday, July 23, 2013 12:57 PM
Tool Specifications
The tool specifications of the machine are listed in the table on
page 165.
Declaration of Conformity
We declare under our sole responsibility that the product
described under "Tool Specifications" is in conformity with the
following standards or standardization documents:
EN 60745 according to the provisions of the directives
2009/125/EG (Regulation 1194/2012), 2011/65/EU,
2004/108/EC, 2006/42/EC.
Technical file (2006/42/EG) at:
Adolf Würth GmbH & Co.KG, PFW,
Reinhold-Würth-Straße 12-17
74653 Künzelsau, Germany
T. Klenk A. Kräutle
General Manager General Manager
Künzelsau: 10.07.2013

Noise/Vibration Information

The measured values of the machine are listed in the table on
page 165.
Noise and vibrational values (vector sum of three directions)
determined according to EN 60745.
The vibration emission level given in this information sheet has
been measured in accordance with a standardised test given
in EN 60745 and may be used to compare one tool with
another. It may be used for a preliminary assessment of expo-
sure.
The declared vibration emission level represents the main
applications of the tool. However if the tool is used for differ-
ent applications, with different accessories or poorly main-
tained, the vibration emission may differ. This may significantly
increase the exposure level over the total working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep hands warm, organise work patterns.
Mounting and Operation
Action
Removing the battery
Inserting the battery
Checking the battery charge
condition
Changing the position of the
auxiliary handle
Mounting application tools
Reversing the rotational direction
Setting the torque
Selecting the drilling position
Setting the operating mode
Gear selection, mechanical
Switching On and Off

Maintenance and Cleaning

 For safe and proper working, always keep the
machine and ventilation slots clean.
Clean the application tool, the tool holder, the power tool's
ventilations slots, and the battery's ventilation slots each time
after using.
If the machine should fail despite the care taken in manufac-
turing and testing procedures, repair should be carried out by
a Würth master-Service.
In all correspondence and spare parts orders, please always
include the article number given on the type plate of the
machine.
The current spare parts list for this power tool can be viewed
in the Internet under
"http://www.wuerth.com/partsmanager"
or be requested from your next Würth branch office.
Guarantee
For this Würth power tool, we provide a guarantee in accord-
ance with the legal/country-specific regulations from the date
of purchase (verified by invoice or delivery document). Dam-
age that has occurred will be corrected by replacement or
repair.
Damage caused by normal wear, overloading or improper
handling is excluded from the guarantee.
Claims can only be accepted if the power tool is sent undisas-
sembled to a Würth branch office, your Würth sales repre-
sentative or a customer service agent for Würth power tools.
Figure Page
1 166
2 166
3 166
4 167
5 167
6 168
7 168
8 169
9 169
10 169
11 170
13