diagrams
0 off
1 low
2 high
3 speed control
4 motor unit
16 Don't run the motor continuously for more than 2 minutes, it may overheat. After 2 minutes
switch off for at least 2 minutes, to recover.
Y PULSE
17 Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In
this direction, the knob is spring-loaded. When you let go, it'll return to 0.
C ADDING INGREDIENTS
18 To add ingredients while the blender is working, remove the cap, pour the new ingredients
through the hole, then replace the cap.
19 Check that the added ingredients don't push the volume in the jug past the 1500ml mark.
C FINISHED?
20 Switch off (0), and wait till the blades come to a stop before removing the lid from the jug, or
removing the jug from the motor unit.
21 Turn the jug anti-clockwise, and lift it off the motor unit.
Y CRUSHED ICE
22 Start with half to threequarters of a cup of ice, or 4 to 6 cubes, and add 15ml (1 tablespoon) of
fresh cold water.
23 Put the lid on the blender, then turn the speed control to Y for a second or two, and release
it.
24 Check the results, and adjust.
C CARE AND MAINTENANCE
25 Switch the appliance off (0) and unplug it.
26 Turn the jug anti-clockwise, and lift it off the motor unit.
27 Wash the jug, lid and cap in warm soapy water, rinse well, then leave the jug to drain and air
dry.
28 Wipe the outside of the motor unit with a clean damp cloth.
29 Don't put any part of the appliance in a dishwasher.
F BLADE UNIT
30 You may remove the blade unit for cleaning.
31 Grip the jug handle with one hand.
32 Grip the jug base with the other hand.
33 Unscrew the jug from the jug base.
34 Carefully, lift the blade unit out of the jug base.
35 Llift the seal away from the blade unit.
36 Wash the seal and blade unit in warm soapy water, rinse, and air dry.
37 Replace the seal round the blade unit.
38 Replace the blade unit in the jug base.
39 Screw the jug into the jug base.
Y pulse
5 jug base
6 blade unit
7 seal
8 jug
9 lid
67
10 hole
11 slots
12 pips
13 cap