Würth 0714 58 229 Traducción Del Manual De Instrucciones De Servicio Original página 12

Problem
It is difficult to wind up the
cutting wire or it breaks.
The suction plates do not
adhere sufficiently to the
windscreen.
The ratchet mechanism is faulty. • The ratchet switching levers are
12
BDA_Scheibenaustrenn-Set_Basic.indd 12
Occurring problems
Cause
• Adhesive bead is too cold and
therefore too hard.
• The cutting wire stops at clips
or spacers.
• High adhesive concentration at
one point.
• The cutting angle is too low.
• The wire is stuck on a body
recess.
• The windscreen is not free of
grease and dirt.
• The vacuum is too low.
• A vacuum cannot be created.
not switched as a pair.
Remedy
• Bring the vehicle up to room
temperature.
• Partially heat up the adhesive bead
in particularly difficult areas using a
hot air gun.
• Route the wire around clips or spac-
ers.
• Heat the point with a hot air gun.
• Move the device so that a more
acute cutting angle is obtained.
• Lever the wire out of the body
recess.
• Clean the windscreen adequately.
• Always ensure the ring marking is
hidden.
• The suction plate is damaged or
the system is not air-tight.
• Always switch the ratchet switching
levers as a pair, i.e. to the same
marking.
11.09.14 17:34