Volume Display Setting; Analog Audio Output Setting; Automatic Display Dimming Setting; Automatic Power Saving Setting - Esoteric N-05XD Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MENU 1 (continued)

Volume display setting

VOLDP>***
This sets the units used to show the volume on the display .
STEP
This shows the volume in steps .
This can be adjusted from 0 to 100 in 0 . 5  steps .
dB1
This shows the volume in decibels .
This can be set to −∞ and −95 . 0 to +24 . 0  dB in 0 . 5 dB increments .
dB2
This shows the volume in decibels .
This can be set to −∞ and −95 . 0 to 0 . 0  dB in 0 . 5 dB increments .

Analog audio output setting

LOUT>***
Use this to select the analog audio output (LINE OUT) connectors to
be used .
o By default, the setting is XLR2 .
ESLA
Analog audio signals are output as ES-LINK Analog (ESL-A)
through the XLR connectors .
o These connections use ordinary XLR cables, but the signals are
transmitted in a unique format, so this setting should only be
used with compatible devices .
o See page 9 for more about ES-LINK Analog (ESL-A) .
XLR2
Analog audio signals are output through the XLR connectors with
pin 2 HOT .
XLR3
Analog audio signals are output through the XLR connectors with
pin 3 HOT .
RCA
Analog audio signals are output through the RCA connectors .
26

Automatic display dimming setting

DPaOFF>***
Use this to set the display to darken automatically .
o By default, the setting is ON .
o If the OEL display is left on with the same indication for a long time,
brightness irregularities can occur . For this reason, we recommend
that you set the automatic display dimming function to ON .
ON
If no operation is conducted for ten minutes, the display automati-
cally turns off .
OFF
The display will not turn off automatically .
o If no operation is conducted for ten minutes, the display will
dim to DIMMER 1 brightness to protect it from excessive wear .

Automatic power saving setting

APS>***
If there is no input from the selected input source for the set time, the
unit will enter standby mode automatically .
o By default, the setting is OFF .
o The input sources that are not selected have no effect on auto-
matic power saving .
OFF
The automatic power saving function is disabled .
30m
30 minutes
60m
60 minutes
90m
90 minutes
120m
120 minutes

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido