MTD Yard Machines Y2900EC Manual De Propietario Y Operador página 5

OPERATING THE EZ-LINK™ SYSTEM
The EZ-Link™ system enables the use of these optional Add-Ons.
Trimmer..............................................................................AF720
Hedge Trimmer* ............................................................... AH720*
Brushcutter* ......................................................................BC720*
Cultivator.......................................................................... GC720
Edger* ............................................................................... LE720*
Pole Saw........................................................................... PS720
Straight Shaft Trimmer ..................................................... SS725
Turbo Blower .................................................................... TB720
* Do NOT use this Add-On with an electric powered unit.
REMOVING THE ADD-ON
1. Turn the knob
counterclockwise to
loosen (Fig. 5).
2. Press and hold the
release button (Fig. 3).
3. While firmly holding the
upper shaft housing,
pull the lower shaft
housing straight out of
the EZ-Link™ coupler
(Fig. 4).
INSTALLING THE ADD-ON
NOTE: To make installing or removing the add-on easier, place
the unit on the ground or on a work bench.
1. Turn knob counterclockwise to loosen (Fig. 5).
2. While firmly holding the add-on, push it straight into the EZ-
Link™ coupler (Fig. 4).
NOTE: Aligning the
release button
with the guide
recess will help
installation (Fig. 3).
3. Turn the knob
clockwise to tighten
(Fig. 5).
For decorative
trimming/edging with the
line cutting head, lock
the release button into
90˚ Edging Hole
the 90° hole (Fig. 5).
INSTALL THE HARNESS
WARNING:
Always use the shoulder harness
when using the cutting blade to avoid serious
personal injury.
1. Push the strap through the center of the buckle.
2. Pull the strap over the cross bar and down through the slot
in the buckle (Fig. 6).
ASSEMBLY INSTRUCTIONS
EZ-Link™ Coupler
Release
Button
Guide Recess
Fig. 3
Primary Hole
Upper Shaft Lower Shaft
Housing
Housing
Fig. 4
(Trimmer Only)
Knob
Fig. 5
Fig. 6
3. Put the harness
on over your head
and onto your
shoulder. Snap it
on to the support
fitting (Fig. 7).
4. Adjust the length
to fit the
operator's size.
Pull the tab to
lengthen, pull the
strap to shorten
(Fig 8).
REMOVE AND INSTALL THE CUTTING SHIELD
Remove the cutting attachment shield when using the unit
as a brushcutter
WARNING:
NOT be installed when operating the unit with a
blade. Remove the cutting attachment shield
before removing or installing the blade.
Remove the cutting attachment shield from the shield mount
by removing the three (3) screws with a flat blade screwdriver
(Fig. 9). Store parts for future use.
Cutting
Attachment
Shield
Shield Mount
WARNING:
cutting attachment shield MUST be in place at all
times while operating the unit as a grass trimmer.
Install the cutting attachment shield when using the unit as
a grass trimmer
Install the cutting attachment shield on the shield mount by
inserting the three (3) screws into the shield mount. Tighten
securely with a flat blade screwdriver (Fig. 9).
5
Support Fitting
Fig. 7
Fig. 8
The cutting attachment shield should
(3) Screws
Gear Housing
Fig. 9
To avoid serious personal injury, the