Replacing The Cutting Insert; Replacing The Spool; Storage; Disposal And Protection Of The Environment - Grizzly Tools 2020-25 Li Traducción Del Manual De Instrucciones Original

GB
Replacing the cutting
insert
1. Slide the cutting insert (13) inward and
push it out of the pin (23) on the cut-
ting disk (12).
2. Place the new cutting insert (13) on
the pin (23) and pull out the insert until
it snaps in.

Replacing the spool

1. Remove the battery (
device.
2. Open the cap (13) by simultaneously
pressing the two releases (20) on the
cap (13).
3. Remove the cover of the cap (13) and
take out the spool.
4. Press the thread ends of the new
spool out of the spool slots.
5. Insert the new spool into the cap (13).
The side of the spool, on which the ro-
tation direction is indicated by arrows,
must be visible after insertion.
6. Insert both ends of the thread through
the opposite line outlet loops.
7. Put the cover (26) back on the cap
(13). Make sure that the releases (20)
on the cover fit precisely into the re-
cesses on the cap (13). They will snap
in noticeably.
Check the line cutter (21). Never
use the device without a line cutter
or with a defective line cutter. If the
line cutter is damaged, be sure to
contact one of our customer ser-
vice centres.
54

Storage

•
•
17) from the
Disposal and protection
of the environment
Remove the battery from the device and
take the device, battery, accessories and
packaging for environmentally friendly
recycling.
•
•
Store the trimmer in a dry place well
out of reach of children.
Do not stand the trimmer on its pro-
tective cover. Suspend it by its upper
handle in such a manner that the pro-
tective cover does not come into con-
tact with other objects. This is because
the protective cover could become
deformed, thereby changing its dimen-
sions and its safety properties.
Electrical appliances must not
be disposed of with the domestic
waste.
Do not throw batteries into domes-
tic waste, fire (risk of explosion)
or water. Damaged batteries can
harm the environment and your
health if poisonous fumes or liq-
uids escape.
Hand the device and the charger to a
recycling point. The plastic and metal
parts used on your device can be
properly sorted according to materials
and grades and efficiently recycled.
Please contact our service centre for
more information.
Dispose of batteries in a discharged
state. We recommend covering the
contacts with an adhesive strip to pro-
tect against short circuits. Do not open
the battery.