After Installation And Connections - Sony XAV-7W Instalación / Conexiones

4 After Installation and Connections

Note
To avoid the possibility of damage, you
should not use a needle or push the
button too strongly.
16
1
Start the car's engine.
2
Verify that the brake lights, other lights, horn, turn
indicators, and all other electrical parts operate
normally.
3
Use a ball-point pen or similar to push the Reset
button on the unit.
Reset button
When you press the Reset button, the system becomes
operative.
Warning when installing in a car without ACC
(accessory) position on the ignition key switch
Be sure to press and hold OFF on the unit for more than two
seconds to turn off the clock display after turning off the
engine.
When you press OFF only momentarily, the clock display does
not turn off and this causes battery wear.